This kind of maintenance can better use the PVC pipe production line

The correct use of the PVC pipe production line can avoid threats to the personal safety of the operators and avoid equipment problems, so that the PVC pipe production line can be better used and bring greater benefits to users.

PVC pipe production line In the factory, the PVC pipe production line must be operated by personnel familiar with the equipment in accordance with the prescribed procedures when installing, debugging (setting the mold, adjusting the blade gap) or disassembling the mold. Always check the sharpness of the mold blade and knife edge. If the knife edge is found to be dull, it should be sharpened or replaced in time. Be sure to stop the operation when changing the mold to avoid danger.

In the factory workshop of the PVC pipe production line, when the PVC pipe production line is in normal operation, please do not put your hands or body parts between the upper and lower mold bases (blade), and do not put any sundries and tools on the workbench to avoid accidents. . Because the PVC pipe production line can be operated by multiple people, a special person must direct the production.

During operation, you must be very careful while holding the workpiece and waiting for the slide to descend. The gap between the shear blade and the die and the radius of the bending fillet must be selected according to the thickness of the copper bar (or aluminum bar).

Keep the oil clean and the oil circuit unblocked. Every shift must lubricate the moving parts of each unit. The electrical and hydraulic components must be flexible in action and accurate in positioning. If any abnormality is found, the operation must be stopped immediately for inspection.

PVC pipe production line.

In order to prolong the service life of the PVC pipe production line, it is generally required to avoid the sun and other heat radiation, and avoid places with excessive humidity, excessive dust or corrosive gas. It is easy to cause corrosion and deterioration of electronic components, resulting in poor contact or short circuits between components, which affects the normal operation of the equipment. The refined PVC pipe production line should be far away from equipment with high vibration such as stamping and forging.

In order to avoid the influence of large power fluctuations (greater than ±10%) and instantaneous interference signals, the PVC pipe production line generally adopts dedicated power supply (for example, a low-voltage power distribution room is divided into one channel for use by CNC machine tools) or a voltage stabilizing device is added to reduce The quality of power supply and the influence of electrical interference.

The safe operation procedure is one of the important measures to ensure the safe production of the PVC pipe production line, and the production personnel must strictly abide by it. When a fault occurs, the operator should pay attention to keeping the site clean, and truthfully explain to the maintenance personnel before and after the fault, so as to facilitate the analysis and diagnosis of the cause of the fault, and to eliminate the fault in time.