What to do if the pipe production equipment fails

Pipe production equipment is a production line that produces pipe materials. The following editor introduces how to deal with the failure of the pipeline equipment production line:

The pipe production equipment is not covered tightly, and the outer glue is not tightly wrapped.

Countermeasures: a make the surface of the pipe have glue, and the vacuum of the glue is good; b increase the temperature of the aluminum strip and turn on the flat tube heating gun;

2. The prism (protrusion) on the surface of the aluminum pipe of the pipe equipment production line

(1) If the pipe production equipment is not sticky, look at which forming wheel the bumps occur in, and look at the aluminum tube coating after which forming wheel corresponds. Dial the aluminum and tube blanks to see the bonding situation after the forming wheel, if you find the tube If there is extruded melt between the blank and the aluminum strip, it means that the temperature is too high. Appropriately reduce the temperature of the air gun heating here. If you find that there is no good adhesion here, you should increase the temperature here or increase the pressure here. , Adjust the pressure roller screw, look at the gap between the aluminum tube and the aluminum tube from the side; the quality of the aluminum tape is defective, such as the film has creases, there are bubbles between the film and the aluminum foil, the film and the aluminum foil are in a block, and some are not The adhesive film has insufficient local peel strength.

2. The position of the molded wheel is incorrect.

Scratches on the surface of aluminum pipes on the pipe production line:

(1) If there are dark lines on the outer cladding surface and impurities in the outer cladding die, the die should be cleaned; because the aluminum strip and the inner tube are not adhered firmly, and the glue remains on the outer cladding die, the outer cladding die should be cleaned. Clean up; adjust the extrusion amount of the outer covering.

There are foreign matter burrs on the supporting roller of the exposed liquid tank on the outer surface; there are foreign matter impurities on the silicone rubber or the cooling water cloth in the sealing liquid tank.

The above is the troubleshooting method of the pipe production line introduced by the editor, I hope it will be helpful to you!